Tutorials

In case you can’t see the printer control panel in CURA, it is because Cura can’t communicate to your printer. This can be due to a lot of things, let’s go through the most obvious ones first. First, make sure that you have installed the CP210x drivers according to this post and restart your computer. https://www.facebook.com/…/permalink/856194115566926/ Try to reconnect the printer a couple of times and wait for 15-20 seconds on...

Cura is G-Code sandbox but it is quite useless in many scenarios because you won’t be able to see what the printer says in response. This is possible with Prontoface. So if you suspect that one or more of your sliders, feeder, or hot-end are not working, you might want to take individual control over each unit and control them individually. Prontoface (PrinerRun) lets you do it more easily. Get if from...

NOTE: For video tutorials, visit Youtube: Click Here Go to windows device manager and plug in your Markhor3D to your computer using a USB cable. The list of devices should flash and a new CP210x UART Bridge Controller device should appear under Ports. If it appears under Other devices, you need drivers that can be downloaded from https://www.silabs.com/…/sof…/CP210x_Windows_Drivers.zip Once the drivers are installed, download Ultimaker CURA from https://ultimaker.com/software/ultimaker-cura, install it, and run it....